New Drop Shadow and Neon effects

[Arwin Profile]

Hi Tony, Im talking about the Tone node.

Adjusting Gaussian Blur node: Radius, Quality
Adjusting Tone node: Brightness, Gamma, Contrast, Exposure, Dehaze

I only see Radius, Quality, Brightness, Dehaze at effects selection


Arwin

[admin]

Hi Arwin,

Which effect is it that you can't see the sliders for?

Tony

[Arwin Profile]

Hi Tony, It's the Drop Shadow White, I see that I did not uploaded it yet (I use it local at the moment), ill sent you the session.

Another thing I discoverd here, is that I had the 'High Performance Display' OFF and wanted to edit the effect (See the sliders from the tone node) and I do get a 'Transform failure' .\ZGeneralPixelOpICC.cpp:113, when switching to 'High Performance Display' ON I can edit the tone node again. Swiching back to OFF I do get the same error again.

Also, in comparison to the .21 version, I can't 'normaly' select an object when 'High Performance Display' OFF, its very stuttering.

Kind regards,
Arwin

[admin]

That's the thing about high performance display, it's high performance! If you turn it off, the software has to do an ICC profile transform every time the image is updated, and depending on the color profile this can be slow. Turned on, it just does it once on load. I'm looking into the other issues.

Tony

[Arwin Profile]

Thanks Tony, so if I understand you right, the 'High Performance Display' OFF did not worked correct in the .21 version aswell as you switched to ON
Glad to see you are on top of the glitches and the program is in a continuous flow of improvement!

Arwin

[Vangelisz Profile]

Hi Arwin,

Can you describe the exact steps when you're getting the "transform failure" message?

Thanks,
Vangelisz

[Arwin Profile]

Hi Vangelisz,

Sure I can, I did had 'High Performance Display' set to OFF (I do thinks the effect it self was created with 'High Performance Display' ON, if thats important to know).
Added the effects 'Drop Shadow White' (Select Area tool, Subject) (Which is a local effect here atm, I did sent the session to Tony though, can send it again to you if you wish)
Opened the effect in the effect editor and clicked on the Tone node, thats the point I get the error.

Regards,
Arwin