editing
Forum rules
You are viewing the Community Help Pages. They are on-line forums where people can come to ask questions about the Smart Photo Editor and all the replies and relevant information are kept in the same place.
You are viewing the Community Help Pages. They are on-line forums where people can come to ask questions about the Smart Photo Editor and all the replies and relevant information are kept in the same place.
2 posts
• Page 1 of 1
- Richard Briggs
- Posts: 379
- Joined: Thu Sep 19, 2013 12:30 am
Re: editing
by Richard Briggs » Fri Dec 02, 2016 10:00 am
The fact that you save to CD has no bearing on your problems (at least as far as I can understand it). So, presumably you get the same problem saving to hard disk?
If the picture is blurry then....
- Either the original photo is blurry (out of focus or the camera moved). A photo may look OK on the camera viewfinder but when blown up (e.g. to print A4) then the problems become apparent.
- Or you used SPE to apply an effect that deliberately blurs the photo. Maybe you did this without realising?
- Finally, you have saved the photo from SPE at a very low resolution. When blown up for printing the pixels in the picture become apparent and give the impression of being blurred.
Richard
If the picture is blurry then....
- Either the original photo is blurry (out of focus or the camera moved). A photo may look OK on the camera viewfinder but when blown up (e.g. to print A4) then the problems become apparent.
- Or you used SPE to apply an effect that deliberately blurs the photo. Maybe you did this without realising?
- Finally, you have saved the photo from SPE at a very low resolution. When blown up for printing the pixels in the picture become apparent and give the impression of being blurred.
Richard
2 posts
• Page 1 of 1
Return to Other Questions About The Software
Who is online
Users browsing this forum: No registered users and 2 guests