Start up failure
5 posts
• Page 1 of 1
Start up failure
Just got failure to start up.
Entry Point Not Found
The procedure entry point
?tabletEvent@Qwidget@@MAEXPAVQTabletEvent@@@Z could not be located in the dynamic link library QtGui4.dll
No idea why..
Have run install again. Seems to have sorted it.
Eric
Entry Point Not Found
The procedure entry point
?tabletEvent@Qwidget@@MAEXPAVQTabletEvent@@@Z could not be located in the dynamic link library QtGui4.dll
No idea why..
Have run install again. Seems to have sorted it.
Eric
Re: Start up failure
Hmm..... just rebooted my computer. Same error after reboot.. Looks like reinstall after every boot up.. Not good....
Re: Start up failure
Even worse than that, tried restarting prog without reboot. Same thing... So reinstall every time I want to use it...
Re: Start up failure
Maybe your shortcut is pointing to an old version of the SmartPhotoEditor. The tablet entrypoint error would happen in that case. What happens if you browse to the location where you installed the software and run the program called "SmartPhotoEditorBeta.exe" from there?
Re: Start up failure
There is only 1 version of "smartphotoeditorbeta.exe" on my computer. The same folder does contain "photoeditorbeta.exe". There are no shortcut issues. Seems to function OK atm. presumably the mutliple reinstalls finally took effect. Your error messages are really unhelpful..
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests