Finish Erasing?
Forum rules
You are viewing the Community Help Pages. They are on-line forums where people can come to ask questions about the Smart Photo Editor and all the replies and relevant information are kept in the same place.
You are viewing the Community Help Pages. They are on-line forums where people can come to ask questions about the Smart Photo Editor and all the replies and relevant information are kept in the same place.
3 posts
• Page 1 of 1
- Richard Briggs
- Posts: 378
- Joined: Thu Sep 19, 2013 12:30 am
Finish Erasing?
by Richard Briggs » Sat Mar 08, 2014 10:01 am
Hi,
Maybe I'm expecting the wrong behaviour here but here goes....
When I replace an area (i.e. what's in the blue area) with the contents of the red area and I am happy with the result, I'm expecting to see some sort of OK button that completes the job and leaves me with a layer that is the new image. I can then do another erase/replace job possibly even over the results I've just achieved. And yet I just seem to end up with this one layer with lots of replaced areas highlighted in blue/red and it all gets a bit messy to work with.
In short, If I have 6 objects, say, that need replacing I'd really like each replace object operation to be on a different layer. Not on the same one.
Richard
Maybe I'm expecting the wrong behaviour here but here goes....
When I replace an area (i.e. what's in the blue area) with the contents of the red area and I am happy with the result, I'm expecting to see some sort of OK button that completes the job and leaves me with a layer that is the new image. I can then do another erase/replace job possibly even over the results I've just achieved. And yet I just seem to end up with this one layer with lots of replaced areas highlighted in blue/red and it all gets a bit messy to work with.
In short, If I have 6 objects, say, that need replacing I'd really like each replace object operation to be on a different layer. Not on the same one.
Richard
Re: Finish Erasing?
by admin » Mon Mar 10, 2014 10:28 am
Yes, if you want a new 'layer', just hit erase again and it will make another erase layer. You can enable 'Ok' and 'Cancel' buttons by going to Settings > Advanced and check 'Left panel is hideable' The OK button doesn't do anything except hide the panel and show the tools again if they are hideable.
Tony
Tony
- Richard Briggs
- Posts: 378
- Joined: Thu Sep 19, 2013 12:30 am
Re: Finish Erasing?
by Richard Briggs » Mon Mar 10, 2014 10:52 am
Thanks, I suspected it would be obvious! Richard
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests