Back up button needed

[norman0000 Profile]

Sometimes one gets part way through a process and then needs to back up to a previous step.

Example: I want to change a sky (excellent feature) and select it as per instructions.

I then go to change it and after checking out a couple of skies realize that I didn't do that great a job on my selection and want to alter it.

There doesn't seem to be a way to do this except for canceling the entire thing and starting over. The 'cancel' button itself is slightly misleading as it doesn't just cancel the effect you selected but means you need to start over completely.

[AngAT Profile]

If you want to change the selection mask for an effect, in your case changing the sky, select the effect from the top bar you want to change and click the right tab which shows the selected area.

You can then refine your selected area for this effect by adjusting the brush size and type.

[norman0000 Profile]

Thank you.
A little back arrow (and forward arrow) would be even easier to use